Products

• Pot life:Approx 4 hrs
• Flexural strength:Minimum 4 MPa
• Tensile strength:Minimum 2 MPa
• Compressive strength:Minimum 20 MPa
• Duration for light foot traffic:6 hrs
• Duration for normal foot traffic:24 hrs
• Duration for heavy foot traffic: 72 hrs
• Duration for grouting:24 hrs

• Premium grade, strong bonding
• Good workability, easy mix with liquid
• High performance, low shrinking
• High compressive, flexural and tensile strength

Surfaces must be structurally strong. Remove all grease, oil, dirt, curing compounds, sealers or any other contaminant that would prevent good bonding. Glossy, lime washed or painted surfaces must be sanded, or abraded, and stripped off all contaminants. Concrete floor must be free of efflorescence and not subject to hydrostatic pressure. Concrete floors should have a course finish to enhance the bond. Roughen the surface by sanding or abrading, then rinse and allow to dry. Use recommended ACEMIX bonding agent for proper bonding between the floor and screed. Expansion joints should never be bridged with setting material. Surface
temperature should be maintained above 10° C or below 38° C to achieve proper bonding. For questions about proper installation, call Technical Services executives on +91 963 260 5577.

Interior and exterior application for domestic, residential, commercial and industrial floors
Old or new concrete floors, cement beds, etc whose compressive strength is greater than 25 Mpa

Recommended substrates:

Old or new concrete floors, cement beds, etc whose compressive strength is greater than 25 MPa.

Cement floors, concrete bed

Masonry

Surface preparation

Surfaces must be structurally strong. Remove all grease, oil, dirt, curing compounds, sealers or any other contaminant that would prevent good bonding. Glossy, lime washed or painted surfaces must be sanded, or abraded, and stripped off all contaminants. Concrete floor must be free of efflorescence and not subject to hydrostatic pressure. Concrete floors should have a course finish to enhance the bond. Roughen the surface by sanding or abrading, then rinse and allow to dry. Use recommended ACEMIX bonding agent for proper bonding between the floor and screed. Expansion joints should never be bridged with setting material. Surface temperature should be maintained above 10° C or below 38° C to achieve proper bonding. For questions about proper installation, call Technical Services executives on +91 963 260 5577.

Pack size:

Available in 30kg

Available Color:

Grey

Shelf life:

12 months if stored in cool and dry area in unopened bag.

Caution:

• Store in cool and dry place.
• High temperature will affect the product.
• Once pack is opened, then finish it off without keeping for long time.
• This product contains epoxy material. Avoid eye contact or prolonged contact with skin.
• Wash thoroughly after handling. If eye contact occurs, flush with water for 15 minutes and consult a physician.
• Do not breathe closely; wear PPE whenever necessary.