Products

• Nonhazardous, safe to use admixture.
  
• High strength, shock and impact resistant
  
• Strong, super flexible, very good adhesion to many substrates
  
• High impact resistance, high mechanical property
  
• Low water absorption, very good water resistance property
  
• No degradation on long term exposure
  
• Suitable for internal and external application

Surfaces must be structurally strong. Remove all grease, oil, dirt, curing compounds, sealers, adhesives or any other contaminant that would prevent good bonding. Glossy or painted surfaces must be sanded, or abraded, and stripped off all contaminants. Concrete or plaster must be cured 28 days prior to bonding unless it is made with Acescreed or Aceplast. Concrete must be free of efflorescence and not subject to hydrostatic pressure. Concrete slabs should have a course finish to enhance the bond. Roughen the surface by sanding or abrading, then rinse and allow to dry. Expansion joints should never be bridged with setting material. Surface temperature should be maintained above 10° C or below 38° C to achieve proper bond. For questions about proper installation, call Technical Services executives on +91 963 260 5577.

Use 5 ltr of Acemix Superflex admixture for mixing 20 kg powder. Take Acemix Superflex in a 20 ltr clean pail and pour powder slowly to the pail under slow mixing. Mix by hand or use a low speed drill mixer (150–200 rpm speed) to achieve a smooth, paste-like consistency. Let the homogeneously mixed adhesive mixture slake or stand 5-10 minutes, stir again and use. Stir occasionally, but do not add water. When properly mixed, troweled ridges will stand without slump.

Used in place of water with thin set adhesive for installation of tiles or stones on most difficult surfaces.
For Installation of ceramic tile, brick, natural stone, porcelain tile on plywood and variety of other substrates.

Pack size:

Available in 5ltr  & 20ltr

Mixing ratio:

5ltr Acemix Superflex admix for 20kg powder